hot water | Plumbing Zone | All Other Country's | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss hot water in the Plumbing Zone | All Other Country's area at Plumbers Forums

A

ajoint

my cousin has an indirect system and to get hot water the heating system has to be on as well,any suggerstions anyone,is the diverter valve stuck?thanks,ajoint
 
have a look at the programmer. its common on older systems not to have independent hot water and heating.
basically if the boiler is on the hw is on and a two port valve gives ch as an option alongside the always on hw.
this can be remedied by the addition of a new programmer/pipe configuration and upgrade to a fully pumped system.
 
Upvote 0
could have a summer valve . follow the pipe from the pump one should go to the cylinder then tee for the htg there may be a manual gate valve on the radiator circuit old systems were like this
 
Upvote 0
Open up the wiring centre and check the wire from the cylinder stat back to the wiring centre and as long as the water is cold in the hot water tank and your programmer is set for hot water to be on you should get 230 ish volts reading on a multimeter but please only do this if you are competent. Also your "cousin" seems to be having a lot of trouble with plumbing?
 
Upvote 0

Similar plumbing topics

At the moment when you move the hot water...
Replies
12
Views
1K
Are you Gas Safe Registered? If not please...
Replies
2
Views
630
  • Question
Go to the manufacturer's of the units you want...
Replies
5
Views
1K
  • Question
Morning, he took it out from where it was...
Replies
11
Views
992
Back
Top