How to change water level? | General DIY Plumbing Forum | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss How to change water level? in the General DIY Plumbing Forum area at Plumbers Forums

Messages
12
Just moved into a rental property and there is a Duavit dual flush toilet - no blockages and the rim/jet holes are clean, but the flush is quite weak. I think the way to improve it might be to increase the water level and I think I have found the float (where I've arroved) but have no idea how to raise it! Any ideas? If it's not already obvious, I really have no clue what I'm doing so if this is something best left to a professional let me know. Thanks so much for any suggestions
Picture1.png
hag
 
float is on the right do you see the pozi screw at the top left of the hole thats your adjustment
 
Screw that posi-looking screw in clockwise that Shaun has indicated, that'll raise the float and raise the water level.

If the tank has been flushing from the level we see in the picture, no wonder you've been having problems. The cistern looks less than half full which will obviously cause a very weak flush.
 
Is the toilet on water mains do you know ?
 
do you have a bath? in the flat
 
whats the bath cold water pressure like ? same as your kitchen tap?
 
Would say it’s water mains then inlet valve may need replacing / new washer and a clean
 

Similar plumbing topics

    • Like
  • Question
Don’t believe what the package says only...
Replies
6
Views
784
Hello! I was checking something in the toilet...
Replies
0
Views
594
  • Question
Thanks for the replies. It took a lot of...
Replies
5
Views
2K
Thank for coming back. Really appreciate you...
Replies
2
Views
935
Thanks very much! Gets me off the hook! Let...
Replies
3
Views
984
Back
Top