hw but no ch | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  • Thread starter g-bone82
  • Start date
  • Replies 3
  • Views 1K

Discuss hw but no ch in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
G

g-bone82

vaillent combi compact fires up for hw but when calling for ch alone fires up for a few seconds then goes out? any suggestions welcome!
 
vaillent combi compact fires up for hw but when calling for ch alone fires up for a few seconds then goes out? any suggestions welcome!
Hi, sounds like you have a blockage in the central heating circuit, or the diverter valve isnt passing to the rads. A combi with a domestic hot water heat exchanger locks itself off from the rads and its output is given through the hotwater. When CH is selected that heat is then pumped into the rads, no circulation then the boiler reaches temp v. quickly then shuts down. Whats the GC number?
 
Hi, Your boiler uses a water valve which may be stuck. Take him out and clean/replace. Check for flow in CH system is poss.

Damian D'Arcy CH4
 
Status
Not open for further replies.

Similar plumbing topics

I don’t know your boiler but would expect it...
Replies
3
Views
739
I've had someone round and I have the answer...
2
Replies
27
Views
3K
WB inform (again) that this (2965) is set to...
Replies
4
Views
729
Thanks for the input on this, much...
Replies
4
Views
998
With CH selected on, if you open a hot tap...
Replies
2
Views
599
Back
Top