- Messages
- 4,293
I went to one of these boilers today put the heating on it fired up all seemed ok until it cut out on temperature as the flow pipe reached 70 degrees.
I was expecting it to fire up when the temperature dropped but it never did.
so I flicked the user control switch off then back on and it fired up and went through the same sequence.
I did this a few times and it fired no problem but this is the only way it would fires even after leaving it for 10 -15 mins
It did not come up with any fault code , it only had the flashing blue light which I know means there is demand but the boiler is up to temp.
I am thinking the flow temp sensor is at fault but there is no info in the MI to test it electricaly
I was expecting it to fire up when the temperature dropped but it never did.
so I flicked the user control switch off then back on and it fired up and went through the same sequence.
I did this a few times and it fired no problem but this is the only way it would fires even after leaving it for 10 -15 mins
It did not come up with any fault code , it only had the flashing blue light which I know means there is demand but the boiler is up to temp.
I am thinking the flow temp sensor is at fault but there is no info in the MI to test it electricaly