ideal | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss ideal in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
I

impo

hi guys i am a sparky over from the dark side
came home today to find the house cold
stat calling pump running but boiler dead
its and ideal classic 250ff 12yrs old fully serviced
took the cover off to see if it was live and spotted the over heat reset button was out so reset it and its been back on 3hrs now and seems ok
any ideas why this could of happened:confused::confused:

thanks mark
 
sludge in boiler, air in system! low water content, has it been drained down lately?
 
darth vader,
if it happens again then you can fault find, sometimes it just happens, with no reason. more likely a temporary power cut, reducing circulation to nowt. it dosnt take ten minutes to hit overheat temp.
obi wan
 
thanks for the replies its ony done it once so far
the last work done on the system was when the thermal store came out and the unvented went in this was april
also had additional rad fitted in august
its been fine till today
 
Status
Not open for further replies.

Similar plumbing topics

Thanks some good ideas. Just as an aside if we...
Replies
10
Views
2K
All sorted. It was a dodgy microswitch in the...
Replies
1
Views
963
  • Question
Ah -- couldn't see "attach files" on my phone...
Replies
4
Views
813
W
pcb issue so gas safe engy required sorry to say
Replies
1
Views
771
More than fine then in 11/5 tube should be...
Replies
3
Views
682
Back
Top