Identify Fittings on HW Tank

[MrPig]

Evening All

Can anyone advise me what these fittings are?
Hot water cylinder, 22 mm pipe, is this a male or female fitting as I'm looking to fit a Warwick flange or similar for a shower pump.

Many Thanks

 

[ShaunCorbs]

22mm Male iron

3/4 or 1” tapping in the cylinder

 

[townfanjon]

Hard to see off this pic but your HW/vent pipe doesn’t look just right, post a pic from further out .

 

[MrPig]

If it helps but, its messy!!

 

[townfanjon]

If the “ snakey “ pipe is the HW / vent pipe , its wrong .

 

[MrPig]

Yes it is, first wobbly pipe is upstand from cylinder, second pic with T junction is feed to taps and vent pipe to tank in loft.

 

[townfanjon]

I have no pics to help you ( anybody)
The pipe should elbow off the top of the cylinder to a very , slightly above horizontal pipe min 450 mm , then the upward tee goes to the CWSC , downward part of tee to taps .
Now is the time to sort it ...

 

[MrPig]

Luckily I am hence the question on fittings.

 

[firemant]

If the “ snakey “ pipe is the HW / vent pipe , its wrong .

Luckily I am hence the question on fittings.

How are you TF? I think Mr Pig meant to add "Thanks for your interest and observations, anyway"

 

[townfanjon]

How are you TF? I think Mr Pig meant to add "Thanks for your interest and observations, anyway"

Lol , to be perfectly honest pal , I am not good , bloody back went again yesterday, I thought I was fixed . Hope you are a lot better than me lol .

 

[firemant]

Lol , to be perfectly honest pal , I am not good , bloody back went again yesterday, I thought I was fixed . Hope you are a lot better than me lol .

TBH, I don't think a proper bad back is ever "fixed". At best, it is okay until the next time. Hope you are back into the fray soon.