immersion heater | Plumbing Jobs | The Job-board | Plumbers Forums
Guest viewing is limited

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

immersion heater

Post thread

Discuss immersion heater in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
should be on its own circuit and have a double pole switch not a fuse spur. normally on a 15/16 amp protection device at the board.
 
Unlike a kettle they spend more than a few minutes turned on
(any deficiencies in wiring will get hot)
 
Status
Not open for further replies.

Similar plumbing topics

VirtuosicVirtuoso
  • Question
Newly installed immersion heater suddenly stopped working after a week. What could be the issue?
Just a thought but did you check the fuse box...
Replies
5
Views
505
Rtplumb
R
G
  • Question
Leaking cylinder around immersion heater
There's no leaks anywhere above it. The water...
Replies
3
Views
360
Gilesda
G
S
  • Article
Electrician Immersion fuse or MCB?
Immersion fuse or MCB? An immersion heater...
Replies
0
Views
1K
Steve-S
S
S
  • Question
Dual immersion heater with sink/bath switch
They are easy to find by Googling once you...
Replies
2
Views
662
Chuck
C
W
  • Question
Pressure reliefe pouring out of unvented immersion heater.
Need a g3 eg unvented engineer
Replies
2
Views
854
ShaunCorbs
ShaunCorbs
Back
Top