Impossible to find replacement bathroom sink parts. Please help!

[adamkwatson]

I am looking for these exact parts to replace my bathroom sink strainer and stopper. I’ve searched every site I can find, but no luck. Does anyone recognize these or where I might be able to buy them?

A little more info:
This sink has a pullout drawer right below, so the waste line is different from most sinks. It runs straight back almost parallel to the floor. A single rubber gasket is between that pipe and the bottom of the sink. There is a hex bolt which is hollow that goes through a hole in the strainer and screws into the waste line, tightening the gasket and sealing it. Then the stopper slides into the hole in the hex screw.

 

[exedon2]

First going to be pedantic its a wash hand basin you wash pots in a sink!
Pic of underside of basin and drawer underneath would be useful can then maybe suggest an alternative.

 

[Aquarius]

This looks similar, can’t be certain though:

McAlpine CP Plastic Backnut Basin Waste Slotted with CP Plug CW1

McAlpine CP Plastic Backnut Basin Waste Slotted with CP Plug CW1 Basin Wastes

hertsplumbingsupplies.co.uk

 

[Scott_D]

Looks like an Ikea item

 

[Ben-gee]

Good spot Scott!

 

[andrewna1]

I am looking for these exact parts to replace my bathroom sink strainer and stopper. I’ve searched every site I can find, but no luck. Does anyone recognize these or where I might be able to buy them?

A little more info:
This sink has a pullout drawer right below, so the waste line is different from most sinks. It runs straight back almost parallel to the floor. A single rubber gasket is between that pipe and the bottom of the sink. There is a hex bolt which is hollow that goes through a hole in the strainer and screws into the waste line, tightening the gasket and sealing it. Then the stopper slides into the hole in the hex screw.

Hi there, I'm looking for the same thing it seems. Did you end up going to ikea to get it? I need to know the dimensions of it before I waste £10 doing click and collect. The one I'm looking for is 64mm in diameter with a 14mm hole in the middle. It's from a vanity unit with a special trap underneath so it runs out of the back. Any advice would be helpful before I spend/waste money unnecessarily. Pic attached Thanks