In screed fitting/valve access box.

[solutions]

Does anybody know of anything that would work as above. Ideally inexpensive and readily available. I need to move a brass stopcock on mdpe from the center of a kitchen unit back to the wall. I can cut the 50mm duct back and break a small trench in the screed and then go from mdpe to copper with a Phil Mac or johnguest fitting but the fitting will end up in the screed and so I would like to keep it a: protected and b: afford better access than simply screeding over. Kitchen is moving in to an extension and existing kitchen knocked through to make bigger lounge.
I know polyplumb have them for underfloor manifolds and such but I'm not sure they will fit larger fittings like the philmac and they always seem pricey for essentially a piece of Tupperware. Any ideas or secret sources out there on't tinterweb?

 

[Ray Stafford]

This

Cheaper than tupperware.

 

[solutions]

This

Cheaper than tupperware.

Thanks ray. Can't log in to your page to check price on my phone can't remember my password PC does that for me. Sadly won't get it in time from you now. Still pushing for a Williams counter in Milton Keynes! That reminds me I must pester that Williams director chap on the forum.