Interesting use of plumbing skills | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  • Thread starter Garryaca@yahoo.
  • Start date
  • Replies 6
  • Views 2K

Discuss Interesting use of plumbing skills in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
G

Garryaca@yahoo.

Useing a few tricks of the trade on my cargo bike!

[DLMURL="http://www.flickr.com/photos/13725084@N05/4338378222"]DSC09219 on Flickr - Photo Sharing![/DLMURL]

[DLMURL="http://www.flickr.com/photos/13725084@N05/4338377694"]DSC09217 on Flickr - Photo Sharing![/DLMURL]

[DLMURL="http://www.flickr.com/photos/13725084@N05/4338377168"]DSC09216 on Flickr - Photo Sharing![/DLMURL]

[DLMURL="http://www.flickr.com/photos/13725084@N05/4338376702"]DSC09215 on Flickr - Photo Sharing![/DLMURL]

[DLMURL="http://www.flickr.com/photos/13725084@N05/4338378222"]DSC09219 on Flickr - Photo Sharing![/DLMURL]
 
Last edited by a moderator:
i bet the fittings are worth more than the bike.R.O.F.L:D:D:D.
i did see a programme recently where a plumber was using his motorbike for work,tooled up and all that,the police who pulled him over were not too impressed though:)
si
 
Ingenious!

I recently bent a piece of 22mm for a shower rail. Customer was really chuffed - and I was too - 3 bends and only 1mm out and ended up totally flat when laid on the floor - fluke!
 
if it were i, i would consider remaking the whole bike with 28mm and guttering for the mud guard.
good rolling add.
i started of as a pipe welder at ralliegh bikes, not much difference.
 
I did get a funny look from the guy at the plumb centre when I turned up on a push bike and bought 3 metres of tube!..

(sliced it in half and strapped it to the top tube)
 
I did get a funny look from the guy at the plumb centre when I turned up on a push bike and bought 3 metres of tube!..

(sliced it in half and strapped it to the top tube)
i remember when all the gas board fitters had push bikes to go out doing the small jobs these were the days before flexi,s on cookers and they were hard piped wasnt unusual for a cooker to have several nipples and socket joining it as they didnt like having to thread anything
they actuallly had a pipe vice fitted on the bike and a small set of stocks and dies in the panniers and a couple of 4 foots of barrel strapped on the cross bar
 
Status
Not open for further replies.

Similar plumbing topics

  • Sticky
  • Question
I never have, but if it were a decent place...
Replies
9
Views
1K
C
I’m not posting here to agree to do/looking...
Replies
1
Views
852
    • Like
Great summary and well done for getting it...
Replies
1
Views
2K
Used knife and 150 grid sand paper the second...
Replies
13
Views
1K
Hi mate i did a fast track MLP course it was...
Replies
1
Views
2K
Back
Top