Intergas Installers

[GasmanxxxR1]

Hi Guys

I have an intergas 36/30 to install next week, ages since i fitted one.......

The condense needs to go into the kitchen sink waste. There is a limited amount of space on the waste pipework but I can fit one of those clamp on boss connectors that will take 21.5 overflow - the standard way i do all my boilers.

My question is how to connect the 21.5 to that corrugated plastic pipe that comes off the intergas. I could always put it into 32mm and the reduce this to 21.5 as there is plenty of room under the boiler. Would the corrugated pipe fit securely on to 21.5?

Thanks in advance

 

[Simon F]

the 21.5mm just pushes tight into the corrugated.
usually get it in about 3"
then from there upsize to what you need.

or run direct to the boss, Didn't read that properly first time!

 

[lame plumber]

as per above

 

[Nostrum]

I bin the corrugated hose off and the trap pushes into an overflow fitting perfectly. Just make sure you can still remove the trap easily. Looks much neater than that flexi cack.