Looking to replace my programmer and am wondering if you guys can help.

[mutley racers]

Good morning chaps. I hope you have all had a good busy week.

I am wanting to update the programmer in my house. I currently have a potterton ep3002. Which is out dated now, so am wondering what you guys are installing these days?

I know you can get programmers that fit onto the back plate of the old one. Which might be a good idea, as mine is mounted into the tiles.

I am not scared to attempt to wire in something new though if you guys do have a preference of some programmer that is top notch.

So, i look forward to your advice.

Hope you're all have a chilled weekend.

Cheers

Mutley

 

[justalex81]

honeywell st9400c is a good shout.

 

[grahamgas]

You will have to check whether all the controls are wired to the ep. They used to wire them all straight to the programmer, instead of a wiring centre, which might severely limit your choice.

As Alex says the honeywell is good as is the Drayton Lp522

Graham

 

[BLOD]

Any of the EP range will fit the backplate
The EP6002 will allow independant control of hot water and heating

If you go for a different make you'll have to replace / rewire the backplate

 

[mutley racers]

Thanks guys, i shall have a look at them all. I do not mind a little bit of wiring. All i would have to do is add a couple of strip connectors for the neutrals and the earths that are wired into the programmer. I think. He he