Loss of pressure & High Pitch Whistle in bathroom | Central Heating Forum | Plumbers Forums
  • Welcome to PlumbersTalk.net

    Welcome to Plumbers' Talk | The new domain for UKPF / Plumbers Forums. Login with your existing details they should all work fine. Please checkout the PT Updates Forum

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

Discuss Loss of pressure & High Pitch Whistle in bathroom in the Central Heating Forum area at Plumbers Forums

Messages
2
Equipment
The shower (a cold feed electric unit) and the Kingspan tank are on the top floor of a 3 storey building. The Ideal Boiler Logic Heat 15 boiler is on the ground floor. The house is 9 years old in May. Both the boiler and Kingspan tank have been serviced in the last month. The shower unit is approximately 3 years old.

Problem
We have two, possibly linked, issues. The first is that two months ago we started to get a high pitched whistle after using the shower. This initially only lasted a few seconds. Now it whistles much longer and can now occur if a tap or the toilet is flushed. It changes note at the very end, going up an octave. It doesn't always occur (such as when a plumber is present) but at least 75% of the time. I have recorded it. The sound doesn't appear to be coming from the shower unit, it sounds above my head (I'm 6ft 4inches tall) when standing in the middle of the bath.

Roughly at the same time we started having to regularly top up the pressure to the Kingspan tank. Having had to pay for a service and service contract costing some £600 in total, I thought I would address both issues. Despite the engineer replacing one of the two small tanks which he says, wasn't holding pressure, the problem appears to be worse. Yesterday I increased the pressure to 1.5 Bars (as I had been told) but today it had dropped to approximately 1.0 Bar. The red hand is pointing to 1.2 Bars.

When the Kingspan Engineer was here, he looked for a probably cause and confirmed that there was no evidence of water leakages inside or out of the house. He suspects its the boiler, possibly the heat exchanger. As these are being quoted as costing £500 plus I need to be sure its the correct solution/answer and can be fixed.

Any suggestions as to how I can proceed to make sure the problem(s) are fixed without costing us an arm and a leg?

Your help is much appreciated.

Many thanks
 
I don’t think it would be the heat exchanger on a heat only logic, but I could be wrong. I would be checking for the pressure relief valve operating (prv), usually visible via a tundish. Is there a loft in the property?
 
I don’t think it would be the heat exchanger on a heat only logic, but I could be wrong. I would be checking for the pressure relief valve operating (prv), usually visible via a tundish. Is there a loft in the property?
Many thanks for your reply. I have checked the prv and its absolutely bone dry.
There is a loft, but on inspecting the noise yesterday, I realised that the noise is probably coming from the duct connected to the ceiling mounted ventilation fan.
 

Similar plumbing topics

Can you post a picture of the vakve?
Replies
4
Views
1K
  • Question
How high is the hill 40m as that will add 4...
Replies
2
Views
440
Thanks very much for your help.
Replies
4
Views
987
Assuming ita a combi boiler then you can set...
Replies
6
Views
1K
Back
Top