Mains Water stopped? | Bathroom Advice | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Mains Water stopped? in the Bathroom Advice area at Plumbers Forums

J

jackplumb

I've going to visit a customer tomorrow who's mains water supply has stopped any ideas?
I do hope that he has paid his bill.
 
Why is everyone assuming its an outside stopcock, internal stopcock or meter.....never think it could simply be the tap itself? Information is very vague, best looking at it before ringing anyone to see if water has been knocked off
 
Maybe I'm missing something here - if the man has no mains water, what can a plumber do about that, other than ringing the water board on his behalf?

Yes but the information is very vague:

Customer: Hello plumber, I have no mains water
Plumber: OK, i'll call out tomorrow

Whose to say the customer simply doesnt have water at one tap which is mains because the tap itself is jammed? Nothin said anywhere about tanks not filling/if pressurized, no hot water or heating. Simply says no mains water, could be a multitude of things :\
 
Yes but the information is very vague:

Customer: Hello plumber, I have no mains water
Plumber: OK, i'll call out tomorrow

Whose to say the customer simply doesnt have water at one tap which is mains because the tap itself is jammed? Nothin said anywhere about tanks not filling/if pressurized, no hot water or heating. Simply says no mains water, could be a multitude of things :\

Original Posts says:-

"I've going to visit a customer tomorrow who's mains water supply has stopped any ideas?
I do hope that he has paid his bill."


Dee...dum..de dum... de..dum....de..dum...de..dum..de..dum! Clouseau strikes again!

....... to be continued!


 

Similar plumbing topics

  • Question
What type of cylinder do you have?
Replies
6
Views
1K
A
  • Question
Contact them again and hope you don’t get the...
Replies
2
Views
501
  • Question
which must be protected by a RCD new circuit...
Replies
8
Views
1K
Murdoch
M
  • Question
I would of clipped the pipework but it is...
Replies
2
Views
373
  • Question
take iso valves off and fit 1/2 inch x 22mm...
Replies
5
Views
832
Back
Top