Millwalkie pipe cutter | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Millwalkie pipe cutter in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
Hello i have had one for a few years and it is a good piece of kit for cutting 28mm but useless for 15-22mm. If you cut a lot of 28mm buy it.
 
Hello i have had one for a few years and it is a good piece of kit for cutting 28mm but useless for 15-22mm. If you cut a lot of 28mm buy it.

How come it's terrible on 15 and 22mm , what's the issues with it, .?
 
I love it. Excellent on 22 and ok on15. U probably need new wheel. I now can't use a traditional slice
 
Ive got a couple of 2.99 nondescript ebay ones. Perfect on both
 
love mine, knackered wrist means slices hurt too much to use, fine on 22mm, bit slow on 15mm, it is just a matter of holding it on the pipe correctly and it works fine. Something about bad workman and blaming tools springs to mind.
 
I thought mine was only good on 28. Until I just squirted some wd40!
Works a treat now on all sizes and has stopped my left wrist hurting too.
 
£220 with 2 x 2amp hr batteries n charger in a bag off seller on bay.
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
Wow thanks, I never thought of redoing the bad...
Replies
7
Views
1K
  • Question
Yep as above Undo the nut slide to the right...
Replies
4
Views
1K
  • Question
Fit a full bore lever valve and remove all the...
Replies
5
Views
842
I can carry it to work in my Gucci handbag though
Replies
22
Views
366
O
  • Article
Are at home Level 2 courses actually viable...
Replies
0
Views
226
OLG0824
O
Back
Top