Mira atom erd problem | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Mira atom erd problem in the Plumbing Jobs | The Job-board area at Plumbers Forums

Messages
5
Hi

I have a bar shower mira atom erd
The problem is the brass thread under the bar shower wher the hose is screwed on to its leaking from inside and drippin from side of the thread. I hope you understand. Mira advised change the temp cartirage and still same problem matter of fact worse

There is a video on youtube showing exavt problem but does not show how its fixed

Please help really annoying
 
Hi

I have a bar shower mira atom erd
The problem is the brass thread under the bar shower wher the hose is screwed on to its leaking from inside and drippin from side of the thread. I hope you understand. Mira advised change the temp cartirage and still same problem matter of fact worse

There is a video on youtube showing exavt problem but does not show how its fixed

Please help really annoying
Under warranty?
 
Ah

Its not leaking from ther
Its dripping from the side of the brass thread the hose is screwed on to
If you put yur finger over the the hole wher the water comes out of the runs down side of the finger i hope this makes sense
 
or get an allen key and tighten it

prob loosened it when you've undone the shower hose
 
Hi

I have a bar shower mira atom erd
The problem is the brass thread under the bar shower wher the hose is screwed on to its leaking from inside and drippin from side of the thread. I hope you understand. Mira advised change the temp cartirage and still same problem matter of fact worse

There is a video on youtube showing exavt problem but does not show how its fixed

Please help really annoying

Did you ever fix this? I have the same problem. I replaced the flow diverter cartridge with no effect.
 
This is either a design or manufacturing fault. Mira knows about this. I had 2 brand new ones installed and both resulted in the same issue. Apparently, all their showers use the same valve. So, even if you replace it with another model, it will result in the same fault. I would suggest buying another brand
 

Similar plumbing topics

  • Question
Thanks hi thanks for reply, turns out after...
Replies
2
Views
3K
  • Question
Much easier than that is to replace your bath...
Replies
3
Views
2K
  • Question
2 and 5 are similar. That's as far as my...
Replies
2
Views
3K
There is 6 pipes under the boiler and one goes...
Replies
19
Views
1K
W
pcb issue so gas safe engy required sorry to say
Replies
1
Views
765
Back
Top