- Messages
- 578
Trying to fit a mixer tap with this sort of fastening. Bit that goes up inside the tap is like a threaded running nipple but when fully screwed in only 40mm produdes and worktop is 40mm thick so no thread to screw nut onto. I am not even sure of the thread size. Across the flats on the nut measures 1 3/8 in or 34mm give or take a gnats. I would prefer to be able to extend the threaded nipple if I knew its size. Other option is I route out a lot of the underside of the worktop, solid oak. Am actuyally assuming is 32mm thread which would tally as one can get 32mm threaded conduit.
Any ideas folks.
Any ideas folks.
Last edited: