- Messages
- 13
Hi everyone, just to say this is my first post, I'm not a professional but have had a lot of DIY experience over the years and installed a couple of systems in my time in my houses through the years. So I'm well aware when I'm out of my depth!
My problem is that I'm on my third motorised valve (heating side). The senario is, firstly, the house electrics trip, and after isolating the heating side motorised valve (two port), from the heating circuit, the house works fine once again. When I connect it back and switch in the heating, the valve takes a few seconds to open, then when the auxillary circuit switch close in the valve, bang, the electric trip again. So the fault is in the auxillary switch circuit of the motorised valve. All well and good, I buy a new one, fit it, then probably about 9 months later, the same thing happens again. I'm on my third now. Please any ideas!!, once, I can put down to a faulty valve, but three times, no. There is something else going on. Help please. I forgot to mention, I only replaced the motor head
Peter
My problem is that I'm on my third motorised valve (heating side). The senario is, firstly, the house electrics trip, and after isolating the heating side motorised valve (two port), from the heating circuit, the house works fine once again. When I connect it back and switch in the heating, the valve takes a few seconds to open, then when the auxillary circuit switch close in the valve, bang, the electric trip again. So the fault is in the auxillary switch circuit of the motorised valve. All well and good, I buy a new one, fit it, then probably about 9 months later, the same thing happens again. I'm on my third now. Please any ideas!!, once, I can put down to a faulty valve, but three times, no. There is something else going on. Help please. I forgot to mention, I only replaced the motor head
Peter