Moving a toilet with an AAV on a floor-exiting soil pipe | Boilers | Plumbers Forums
  • Welcome to PlumbersTalk.net

    Welcome to Plumbers' Talk | The new domain for UKPF / Plumbers Forums. Login with your existing details they should all work fine. Please checkout the PT Updates Forum

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

Discuss Moving a toilet with an AAV on a floor-exiting soil pipe in the Boilers area at Plumbers Forums

Status
Not open for further replies.
R

Rahaaas

Hi all,

Picture available here:

https://www.dropbox.com/s/l3k899oghtfbuad/IMG_1414s.jpg?dl=0

I'd like to replace this toilet with a close-coupled unit further to the right (so I can actually open the door...), while reducing the boxwork (particularly on the left hand side) as much as possible. Low-level boxwork on the right is inevitable, I suspect, keen to avoid building a false wall / large cabinet.

The wastes come from the high-level cistern, bath (just to the right, out of picture) and sink. It's in the basement floor of a 5-storey Georgian conversion, and can't be externally vented directly. The soil pipe runs about 15ft to an inspection cover that serves the rest of the building, and that IS externally vented.

Question is, can I get a toilet running straight down into the soil pipe, and run an AAV off to the right (even under the bath void), running the wastes in there too? Or can the toilet go on the right of the soil pipe, swan-neck in, and connect to the AAV running off to the right?

Assuming I can't dispense with this big stack and use discrete AAVs on the bath and sink wastes, right..?

There's some reticence (understandably) from our installer to chase into the concrete floor / very thick wall, or dig around the soil pipe itself.

Thanks for reading... suggestions gratefully welcomed!
 
Last edited by a moderator:
The wastes come from the high-level cistern, bath (just to the right, out of picture) and sink. It's in a 5-storey Georgian conversion, and the stack is about 15ft from an inspection cover that leads off to an externally vented stink pipe. There's no way to externally vent this installation as it's in the basement!

i don't understand this bit, your saying the stack is vented outside then in the same sentence you can't vent it.
 
Sorry if that isn't clear. I know that the soil pip runs through our flat, to an inspection cover in our garden. A few feet from there, there's a vent pipe running up the side of the house, above the roofline. So my assumption is that there is a vent from the sewer, but this particular soil pipe isn't directly vented. From what I can gather, this may mean we can dispense with the big AAC and use small 'auxiliary' AAVs on the bath / sink traps, as the sewer is vented as part of a larger system...
 
Status
Not open for further replies.

Similar plumbing topics

10 o’clock / 45 degrees would be better than...
Replies
3
Views
577
Sorry for the late post on this but just...
Replies
23
Views
2K
Thanks yes I've seen that but it doesn't give...
Replies
2
Views
4K
Thanks mate, thats really helpful photo, and...
Replies
8
Views
1K
Back
Top