Naughty Naughty Naughty | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Naughty Naughty Naughty in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,168
This is a 1st for me. Usually flexi's connecting a hob.

Called to a smell of gas...

20180327_083300.jpg
 
Normally cut the upstand off and use a flat face washer
 
It's track pipe so that is fine. It is the compression fitting onto a flat faces washer fitting.

You Can file the threads flat though
 
dont see many bent tap connectors, cost more than a st elbow and nut and olive.

did it have the barrier between the top draw and hob underside? the number of kitchen fitters that hate me when i insist on the barrier being fitted is getting quite high.
 
dont see many bent tap connectors, cost more than a st elbow and nut and olive.

did it have the barrier between the top draw and hob underside? the number of kitchen fitters that hate me when i insist on the barrier being fitted is getting quite high.
Can't say I have ever seen a barrier fitted, didn't know there was such a thing
 
Status
Not open for further replies.

Similar plumbing topics

Experience tells me 10mm won't be enough but...
Replies
5
Views
846
T
  • Question
For about a year, my shower on a third floor...
Replies
0
Views
584
Timmy1
T
Outside of using a gas-safe LPG engineer, do I...
Replies
0
Views
652
Thank you for keeping me safe. If it is the...
Replies
2
Views
580
Back
Top