New standpipe for tumble dryer waste | General DIY Plumbing Forum | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss New standpipe for tumble dryer waste in the General DIY Plumbing Forum area at Plumbers Forums

Messages
3
Does a new stand pipe for a tumble dryer waste water drain need to be vented (i.e. open at the top) or can i put an end cap on it? Is a P trap needed? I cant connect it to the washing machine so need to install new pipework to drain loosely into an outside drain. I want to connect the hose to a nozzle rather that hanging loosely in the top of the pipework
 
What are you planning on teeing into eg another pipe or just into a gully ?
 
What are you planning on teeing into eg another pipe or just into a gully ?
Most likely just into a gully. I could T into an existing pipe but seems unnecessary.
 

Attachments

  • 20211127_145935.jpg
    20211127_145935.jpg
    886.3 KB · Views: 29
  • 20211127_195352.jpg
    20211127_195352.jpg
    1.1 MB · Views: 28
Doesn’t need to be vented so you do what you like
 

Similar plumbing topics

  • Question
To add to this, ensure the discharge hose...
Replies
2
Views
1K
  • Question
thanks Timmy didn't know about the max length...
Replies
2
Views
1K
  • Question
Will do, I shall try that. Thank you for your...
Replies
6
Views
1K
  • Question
Correct. Bleed from bottom up to allow air...
Replies
3
Views
1K
  • Question
You’d know if that had no trap as the smells...
Replies
1
Views
1K
Claymore
C
Back
Top