Old waste pipe size help

[Marky22]

Hi,

came across this old push fit waste pipe. Stripped out the old shower and it was a 40mm waste pipe siliconed in the fitting.
The fittings at floor level so I’d be looking to bend (90 degrees) straight away so I can get the lowest possible shower tray.

Could someone advise what I could use you as 50mm pipe is from the standard screwfix is too big.

Any help would be greatly appreciated.

Thanks

 

[ShaunCorbs]

The old piece of pipe is left in there you can see the outline of it is that roughly the same size as 2” waste pipe ?

 

[Marky22]

The old piece of pipe is left in there you can see the outline of it is that roughly the same size as 2” waste pipe ?

No there’s no pipe left in there. It’s just the rubber seal/o-ring for the pish fit that’s in there

 

[ShaunCorbs]

50mm (2") x 40mm (1-1/2") Push Fit Waste Fitting Reducer

Pushes into a 50mm (2 inch) fitting to let it accept a 40mm (1-1/2 inch) push fit waste pipe

www.stevensonplumbing.co.uk