"Open" Backnut Spanner | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss "Open" Backnut Spanner in the Plumbing Jobs | The Job-board area at Plumbers Forums

TBH you could make that / have a local fab shop bend something

Never see anything like that myself
 
If you mean the 35mm big nut job then yes - quite right. For monos those with a C clamp I still use(d) a deep thin walled socket no matter whether they rigid or flexi.

never seen a horse shoe nut being 3" dia :D
 
Hello everyone and thank you for all your responses!

I managed to get hold of one after all from Franke, the part number is 133.0503.819 and you can get it from Central Services.

The tool makes it much easier to tighten the nut without removing the flexible hoses, especially in very tight places (our worktop is a one-piece integral unit).

Once again, thank you all!

KP
 
You sure about that part number? It`s not bringing anything up at Franke or Central Services.
 

Similar plumbing topics

  • Question
Many thanks for the advice.
Replies
3
Views
864
Just a guess, but you may find that the...
Replies
5
Views
2K
Heating repaired. Was the central heating zone...
Replies
14
Views
2K
As a young man i installed a lot of one pipe...
Replies
25
Views
7K
Should have it done in a day. If you’re a bit...
Replies
5
Views
17K
Back
Top