Outdoor insulation for overflow pipe | Plumbing Jobs | The Job-board | Plumbers Forums
  • Welcome to PlumbersTalk.net

    Welcome to Plumbers' Talk | The new domain for UKPF / Plumbers Forums. Login with your existing details they should all work fine. Please checkout the PT Updates Forum

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

Discuss Outdoor insulation for overflow pipe in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

Eyespy999

Plumbers Arms member
Plumber
Messages
148
evening,

I am looking at insulating a plastic overflow pipe 21.5mm? They have some cheap insultion down at wickes but looking at something that will last and not disolve with uv. Any reccomendation please?

Cheers!
 
evening,

I am looking at insulating a plastic overflow pipe 21.5mm? They have some cheap insultion down at wickes but looking at something that will last and not disolve with uv. Any reccomendation please?

Cheers!
Hi Eyespy,
I would recommend this pipe insulation never had an issue with this one.
[DLMURL]http://www.wickes.co.uk/Wickes-Economy-Pipe-Insulation-22mm-x-13mm-x-2m/p/137657[/DLMURL]
 
Last edited by a moderator:
Snowhead is right. It should be upgraded really if 21.5mm is ran externally.
 
Climaflex pipe insulation is rot proof and Non-Hydroscopic, it offers greater thermal conductivity than economy pipe insulation which only has a 13mm wall thickness it has a 25mm wall thickness. You can get it at most DIY outlets including screwfix. It would be good to know what the overflow is connected to though as mentioned above if its from the boiler it is not the correct size for external use.
 
Hi all thanks for the advice, it is a condensate pipe that is going to be insulated, it was installed a couple of years ago. I am going to be doing a power flush at the customers address and have been asked to insulate the pipe.
 
Eyespy, you could probably make a bit more money by upgrading it to 32mm. If you check the boiler manufacturer's installation instructions most I've seen insist on 32mm when the condensate pipe runs externally. To be honest, when we fit them we run them through the cavity wall in 40mm and out to the drain. No difference in cost really between them and it's certainly not going to freeze up in Winter!
 
Status
Not open for further replies.

Similar plumbing topics

Just to round this off with what I found here...
Replies
5
Views
604
  • Question
Screwfix part number 472FY BES...
Replies
4
Views
1K
  • Question
Just screwdrivers. Although it’s wise to back...
Replies
3
Views
512
  • Question
Any thoughts on this bottle gully arrangement?
Replies
6
Views
626
Back
Top