overflow prob | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss overflow prob in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
T

tel

hiya changed ballvalve on overflowing dom tank recently , just been back to it this morning with same problem ,there is no boiler in house but there is a old proscot stat and an old hotpoint water heater on cylinder could there be a problem with stat or heater not turning off and how do i find out or do i ring a sparks

any advice please
 
does the stat click when you move it through its temp range? if it does then check for it switching the immersion on/off using a multi meter. If it is jammed on it will need replacing, best get a sparks/plumber in to do the repairs and confirm all is well
 
I had a problem like that on a job it was a shower valve passing mains into the hot side defective none return in shower
 
After the second phonecall from the cutomer you begin to think your losing the plot:)
 
like when the coil goes on a cylinder had 2 in one week
Big problem and more likely to happen when new pressurised system fitted to old cylinder, much more difficult to prove than with open vented system also.
Martin.
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
Thanks. That was my thoughts. I assumed if...
Replies
12
Views
2K
Will try to upload pic again
Replies
4
Views
1K
I once had a similar experience with my old...
Replies
6
Views
966
C
I’m not posting here to agree to do/looking...
Replies
1
Views
852
OK, but from the boiler it should be Vent then...
Replies
16
Views
2K
Back
Top