Own up :D ............

[ShaunCorbs]

come on own up whose done this

Why o why and they were plumbers

 

[Harvest Fields]

Been to a house today and everything hot and cold was done in speedfit. Looked an absolute mess. If I go back I’ll take a pic.

 

[ShaunCorbs]

Been to a house today and everything hot and cold was done in speedfit. Looked an absolute mess. If I go back I’ll take a pic.

This is done in Miss matched stuff

Speedfit fittings or compression
Speedfit pipe
Floplast pipe
Cheap Chinese crud



Now I've got to join onto it somehow

 

[townfanjon]

Seeing more of it , Pathetic

 

[townfanjon]

View attachment 33153

I hope you are going to varnish that

 

[Harvest Fields]

This is done in Miss matched stuff

Speedfit fittings or compression
Speedfit pipe
Floplast pipe
Cheap Chinese crud



Now I've got to join onto it somehow

View attachment 33153

Oooohhhhhh.
On a more important note. How the hell is that copper so clean? And are you made of money with them clips?

 

[ShaunCorbs]

I hope you are going to varnish that

naaa don't think I will

 

[ShaunCorbs]

Oooohhhhhh.
On a more important note. How the hell is that copper so clean? And are you made of money with them clips?

I don't know haven't even had the wire wool out yet

Works out cheaper than plastic clips stand offs and joiners about £1 per brass clip

 

[Harvest Fields]

I don't know haven't even had the wire wool out yet

Works out cheaper than plastic clips stand offs and joiners about £1 per brass clip

Looks good though.

 

[ShaunCorbs]

Looks good though.

It does

Had to do a middle row else maggy would be a pain to set and release, could of prob done just maggy but would of looked a bit off

 

[Harvest Fields]

It does

Had to do a middle row else maggy would be a pain to set and release, could of prob done just maggy but would of looked a bit off

What you fitting

 

[ShaunCorbs]

What you fitting

I'm not moving a 29cdi classic that I didn't decom so that might be fun

Let's see if it will run again

 

[Harvest Fields]

I'm not moving a 29cdi classic that I didn't decom so that might be fun

Let's see if it will run again

You’ll be fine

 

[ShaunCorbs]

You’ll be fine

Yep should I be concerned that it had water in the air inlet

 

[Harvest Fields]

Yep should I be concerned that it had water in the air inlet

Errrr...

 

[ShaunCorbs]

Don't think I did too bad

Had to do some weird angles to match up to the plastic (took long to do them 3 than to pipe up the boiler)

 

[Best]

I think I would have used a bit of the horrible plastic pipe to do the awkward bends and kept my copper looking normal.
Tbh, I really try to avoid jobs like that unless I can get the customer to agree to ripping it out.
The plumbing has reached a new low with all this plastic multi brand rubbish

 

[ShaunCorbs]

I was thinking about that but i would of still had to use an extra coupling and elbow as the bend at the top is too tight so better to do it in copper if I have to faff around like that

prob could of done that but don't think my builder mate would of liked me afterwards

And agree too much