Please help, pressure low. | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

Discuss Please help, pressure low. in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
Messages
4
F35991DE-EE21-46FF-983B-EB37A2436DF5.jpeg
FB6395DC-C408-4B95-A444-F516659E807E.jpeg
This may sound stupid. I have a potterton boiler. And it’s saying E1. Have worked out pressure is low. But there’s no filling loop etc. Please help as we have no hot water or heating.
 
As you look under the boiler you will see 2 black dials that link together, that is your filling loop all you need to do is turn them both and your boiler should fill up, once you reach 1 to 1.5 bar turn them off, but I would have you boiler checked by a registered engineer as it looks like you might have a leak as there is some corrosion under the boiler.
 
As you look under the boiler you will see 2 black dials that link together, that is your filling loop all you need to do is turn them both and your boiler should fill up, once you reach 1 to 1.5 bar turn them off, but I would have you boiler checked by a registered engineer as it looks like you might have a leak as there is some corrosion under the boiler.
Have had a look, and there is non that link together. That’s the confusing part. Any ideas please?
 
directly below the boiler on the right hand side i have circled on the picture.

F35991DE-EE21-46FF-983B-EB37A2436DF5.jpeg
 
do the knobs open fully then stop turning or do they carry on turning?
the left should turn anti clockwise and the right clockwise
 
Undo the screw which holds the handle on pull it off and use a small adjustable spanner to turn the filling loop valve on you should hear it filling
 
Status
Not open for further replies.

Similar plumbing topics

fill only to 1bar when cold.
Replies
1
Views
542
Have you got a photo of the sink at the...
Replies
2
Views
617
C
  • Question
Is there a ball valve on the flexihoses? Might...
Replies
1
Views
946
  • Question
Just to add, I’ve notice the pressure gauge...
Replies
3
Views
1K
You might have a EV (expansion vessel)...
Replies
7
Views
608
Back
Top