Plinth Heaters | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  • Thread starter loughtonlion
  • Start date
  • Replies 1
  • Views 4K

Discuss Plinth Heaters in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
L

loughtonlion

Hi. Fitting a new kitchen and am going to install hydronic plinth heaters. Anyone got any advice on which make to use and where to get the best price? Smiths seem to be recommended, but expensive. I plan on fitting two to the 30 cubic metre kitchen, one dual electric/hydronic.
Many thanks, Steve.
 
Hi. Fitting a new kitchen and am going to install hydronic plinth heaters. Anyone got any advice on which make to use and where to get the best price? Smiths seem to be recommended, but expensive. I plan on fitting two to the 30 cubic metre kitchen, one dual electric/hydronic.
Many thanks, Steve.
I fitted a Smiths plinth heater in my kitchen 4 years ago. It's a little bit noisy but very good.
 
Status
Not open for further replies.

Similar plumbing topics

Have you got a photo of the sink at the...
Replies
2
Views
633
E
Is it an unvented cylinder? Sounds like issue...
Replies
3
Views
1K
  • Locked
If radiator was piping hot on 10mm, then so...
Replies
20
Views
8K
I started a long winded response but deleted...
Replies
1
Views
794
Heating water using electric is about 3 x the...
Replies
2
Views
1K
Murdoch
M
Back
Top