Guys looking for some advice
I have a property that we are working on we have the following
gnd flr
wc
kitchen with dishwasher and one basin
water softener
1st flr
ensuite
shower toilet and basin
ensuite 2
shower basin bath and toilet
2nd flr
shower
basin
toilet
washing machine
We have a 32mdpe coming in reduced to a 28mm then into a water softner then a 22mm to boiler which is positioned on the 1st floor. We have a worchester bosch system boiler and a joule 250ltr unvented cylinder. Our pressure is 2.2bar and the flow rate coming into the property is 25lpm
At the moment we are getting complaints that the water is not reaching the 2nd floor area the loft so after investigations and by-passing the combination valve we found that the combination valve on cylinder was faulty as all showers worked fine when bypassed. We replaced the combination valve and this did improve the water to upstairs (loft) as it comes out now but when we turn on all 3 showers it drops. My plumber has recommended upgrading the combination valve to a 28mm from the 22mm installed.
Will this help in any way ? ?
Regards
Tim
I have a property that we are working on we have the following
gnd flr
wc
kitchen with dishwasher and one basin
water softener
1st flr
ensuite
shower toilet and basin
ensuite 2
shower basin bath and toilet
2nd flr
shower
basin
toilet
washing machine
We have a 32mdpe coming in reduced to a 28mm then into a water softner then a 22mm to boiler which is positioned on the 1st floor. We have a worchester bosch system boiler and a joule 250ltr unvented cylinder. Our pressure is 2.2bar and the flow rate coming into the property is 25lpm
At the moment we are getting complaints that the water is not reaching the 2nd floor area the loft so after investigations and by-passing the combination valve we found that the combination valve on cylinder was faulty as all showers worked fine when bypassed. We replaced the combination valve and this did improve the water to upstairs (loft) as it comes out now but when we turn on all 3 showers it drops. My plumber has recommended upgrading the combination valve to a 28mm from the 22mm installed.
Will this help in any way ? ?
Regards
Tim