Hi guys,
I have been working on this potterton today, dhw pin was sluggish and diverter was passing through to CH on DHW demand. Changed diaghpram on DHW, and three was diverter block.
Whilst off, also decided to put some chemicals through the plate HEX. Where I found broken bits of flow restricted venturi.
Put it all back together but dhw spindle is still sluggish to extend fully on sink tap. When using bath tap it extends, but then doesn't retract back fully. Dhw at kicthen sink is at nearly same pressure as cold water, obviously due to broken flow restricted cartridge.
But just need to confirm if this full pressure is causing the slow dhw pin? It is £90 for the inlet hydro block. Flow restricted cartridge with venturi is not available seperately.
Thanks for input.
Nuran
I have been working on this potterton today, dhw pin was sluggish and diverter was passing through to CH on DHW demand. Changed diaghpram on DHW, and three was diverter block.
Whilst off, also decided to put some chemicals through the plate HEX. Where I found broken bits of flow restricted venturi.
Put it all back together but dhw spindle is still sluggish to extend fully on sink tap. When using bath tap it extends, but then doesn't retract back fully. Dhw at kicthen sink is at nearly same pressure as cold water, obviously due to broken flow restricted cartridge.
But just need to confirm if this full pressure is causing the slow dhw pin? It is £90 for the inlet hydro block. Flow restricted cartridge with venturi is not available seperately.
Thanks for input.
Nuran