Problem radiator | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Problem radiator in the Plumbing Jobs | The Job-board area at Plumbers Forums

Messages
6
We live in a bungalow and have a problem radiator that will not heat up at all. My OH has changed the thermostatic valve, tried bleeding it and has this morning taken radiator off and flushed it, still cannot get any heat from it, appeared to start heating up when he had bleed valve open then stopped when he closed it. Now nothing at all. The radiator was not full of sludge when he emptied it. We have a magna filter on system. All the other radiators are hot on the top and cold on the bottom! Can anyone advise please. Have asked 2 or 3 plumbers to look at it for us but no one seems interested.
 
Radiators hot at the top and cool at the bottom is a possible sign of sludge building up in the bottom of the radiator.

You need a good plumber to assess the system - where abouts are you?
 
Radiators hot at the top and cool at the bottom is a possible sign of sludge building up in the bottom of the radiator.

You need a good plumber to assess the system - where abouts are you?
Gateshead, Near Washington. He has flushed one radiator wasnt any sludge?
[automerge]1570627170[/automerge]
Have you tried turning all the other radiators off to see if the problem one gets hot?
Have you opened the valves into a container to make sure both valves are working correctly?
Will suggest what you have said, Thank you.
 
Hot on top cold at bottom....the system is sludged up. Maybe the naughty rad is blocked by sludge further back. Close off flow and return to boiler to keep sludge out of boiler set up false flow and return with mains in flushed water out to a drain via drain offs. close all rads off bar one and spend a happy day going round and round with a strong magnet and or rubber hammer to loosen up the ferric oxide...check magna clean see hiw much it gets
centralheatking ...if its a conventional system use a champers cork to block expansion to roof tank ...centralheatking
 
Hot on top cold at bottom....the system is sludged up. Maybe the naughty rad is blocked by sludge further back. Close off flow and return to boiler to keep sludge out of boiler set up false flow and return with mains in flushed water out to a drain via drain offs. close all rads off bar one and spend a happy day going round and round with a strong magnet and or rubber hammer to loosen up the ferric oxide...check magna clean see hiw much it gets
centralheatking ...if its a conventional system use a champers cork to block expansion to roof tank ...centralheatking
Thank u so much, will get hubby on the case.
 

Similar plumbing topics

Pin hole leak on suction side of pump.
Replies
1
Views
512
  • Question
Well done for sorting it. Waggling the trv pin...
Replies
7
Views
1K
  • Question
Will be a 15-60 then prob ups2 Green lights ?
Replies
8
Views
1K
1/4 turn black knob on both. open bleed screw...
Replies
7
Views
934
  • Question
It’s expansion and contraction do you have the...
Replies
1
Views
559
Back
Top