Pump for underfloor manifold | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Pump for underfloor manifold in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

Chalked

Esteemed
Plumber
Gas Engineer
Messages
5,012
Hi sll

have 4 new build houses in York that have flooded. They need me to get the heating working asap.
i have fitted on the ground floor underfloor heating it's a Grunfoss ups 25-40/60. Is it a special or would any Grunfoss pump fit and work.
all were under 3ft of water. I could order replacements from supplier (Wundafloor) but that would take a couple of days.
 
any grun would work
 
be a while till the electrics are safe and won't the gas meters be a bit full as well, bit more more haste less speed up there, the poor sods wont get dried out much quicker, especially when tomorrows storm hits.
 
meters shouldnt be floded but the regulators might be a problem with water above the diaphrams but ng should come out and change if there a problem
 
Status
Not open for further replies.

Similar plumbing topics

I started a long winded response but deleted...
Replies
1
Views
789
Good point. My daughter rang me yesterday and...
Replies
20
Views
4K
Anyway, you can always increase the boiler...
Replies
16
Views
2K
S
Sketch/ pictures of your existing pipework...
Replies
3
Views
948
Hi folks, thought I's just close this out with...
Replies
19
Views
2K
Back
Top