Hi all.
Quick question.
Pushfit/speedfit on an unvented. I believe the reg's are that it's not allowed within 1 metre of cylinder?
Is this true?
I have fitted thermal stores where the manufacturer actually tells you not to solder directly to the store, or use compression, but use a pushfit.
If you were to cap a secondary return to an unvented cylinder, and did it via a compression coupling/short length of pipe/ and a JG Speed Fit stop end. Would you be contradicting regs?
Thanks.
Quick question.
Pushfit/speedfit on an unvented. I believe the reg's are that it's not allowed within 1 metre of cylinder?
Is this true?
I have fitted thermal stores where the manufacturer actually tells you not to solder directly to the store, or use compression, but use a pushfit.
If you were to cap a secondary return to an unvented cylinder, and did it via a compression coupling/short length of pipe/ and a JG Speed Fit stop end. Would you be contradicting regs?
Thanks.