- Messages
- 3,311
Hi folks, me again I'm afraid.
So after realising my flow temp on UFH is set to 62C made the mistake of turning the mixing valve down on the JG Speedfit manifold today. It has started to leak like crazy from the spindle. I can only stop it leaking by turning it up to 62C but that's way too high a temperature (probably explains why it is set to that though). The manifold and control set are the old ones pre-2014. Does anyone know where (or if) I can buy a suitable replacement mixing valve only? Didn't know if it was possible to buy the brass body of the valve still and just replace that. I've had a quick look around the web and can't see anything suitable.
Hopefully someone has walked this road before and there is a cheap solution! The system is being fully drained down this weekend so it's an ideal time to replace it really if I can find the part in time.
Thanks in advance,
Keiran.
So after realising my flow temp on UFH is set to 62C made the mistake of turning the mixing valve down on the JG Speedfit manifold today. It has started to leak like crazy from the spindle. I can only stop it leaking by turning it up to 62C but that's way too high a temperature (probably explains why it is set to that though). The manifold and control set are the old ones pre-2014. Does anyone know where (or if) I can buy a suitable replacement mixing valve only? Didn't know if it was possible to buy the brass body of the valve still and just replace that. I've had a quick look around the web and can't see anything suitable.
Hopefully someone has walked this road before and there is a cheap solution! The system is being fully drained down this weekend so it's an ideal time to replace it really if I can find the part in time.
Thanks in advance,
Keiran.
