Removing copper soil stack | Boilers | Plumbers Forums
  • Welcome to PlumbersTalk.net

    Welcome to Plumbers' Talk | The new domain for UKPF / Plumbers Forums. Login with your existing details they should all work fine. Please checkout the PT Updates Forum

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

Discuss Removing copper soil stack in the Boilers area at Plumbers Forums

Status
Not open for further replies.
Messages
20
hi.
I have a copper soil stack (def copper) that I am hoping to take out, runs through the house, pops out the roof, which is leaking anyway!

What’s the best way to connect? I plan on cutting a couple inches before the pipe goes underground, can I stick a connector in, assuming it fits like
https://www.NoLinkingToThis/p/mcalpine-dc1-bl-drain-connector-black-110mm/4255v

Or is it easier to use a large flexible connector? If it’s clipped correctly, surely this is fine?
Can get pics tomorrow if needed

Cheers
Edd
 
It really needs to be replaced into the ground, it shouln't be too far down.
The connector in your link will work into the copper.

I work on commercial and we have a lot of copper soil pipe.
It nearly always ends up leaking at floor level.
 
Cheers for replies.

Have attached a couple of photos,
05CC2717-783C-49D0-BEED-C109F2BA9650.jpeg

156D7D80-6DD8-4656-B406-70440B162BD7.jpeg


So just chisel the cement mound away and I should see where the copper goes to the underground drain?

Then do I use the connector in the clay drain(buried), and cement it all back in (including inch or so of plastic pipe)
Or just pull it close, silicone and cement?

Cheers
Edd
 
I would get the grinder out bud get it all stripped out chip out the cement work out at low level to free the lowest part of the copper into the ground when you have make sure no mortar falls in the drain a black bin liner with screwed up news paper in push in the open will protect it clean out the collar then cement in a access pipe with a 110mm collar then is time to reinstall the stack . Kop
 
Never seen a copper soil stack before. Any pics showing how any connections were joined to it?
 
Same as that. It's usually asbestos, cast, plastic or steel. Bet that's worth a fortune in scrap!
 
Status
Not open for further replies.

Similar plumbing topics

Thought as much. May as well buy the orange...
Replies
5
Views
2K
If poss i would run to outside to stack.
Replies
1
Views
4K
It will work fine, just keep doing the nuts up...
Replies
9
Views
4K
Yes Depends just a washing machine/ dish then...
Replies
3
Views
919
  • Locked
Looking at the pic, I would say you would need...
Replies
1
Views
1K
Back
Top