rems pressure test pump 110 volts | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss rems pressure test pump 110 volts in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

carrpaul

Gas Engineer
Messages
97
hi there any one had any dealing with rems pressure test electric test pumps ? or any other electric test pumps ?
 
was on a job with a mate of mine who used one years and years ago was a 8 bed with full underfloor heating downstairs and rads up and in the loft he was amazed by it I didn't take much notice as I was rodding the pigging drains after the tiler had washed his buckets out the previous day and blocked them!
 
Ok thanks not a big job just houses new build 5 a week , as I had my hand pump pinched last week
 
just get a decent hand pump and a coil of plastic connected to a cold main. fill up on the cold main, isolate and then pump up with the pump test and then flush and drain. should only take 2-3mins to pump up. quicker than an electric one imo and you dont need any power and alot of cash. leave a gauge on the test and remove the test pump and put it away so it cant get nicked.

and not having to worry about it getting nicked(the electric tester) while you lagg and trac tape up helps too.
 
Last edited:
Status
Not open for further replies.

Similar plumbing topics

  • Question
I would be concerned about the 5.5 bar...
Replies
1
Views
1K
  • Question
Have you have checked there is a live feed to...
Replies
1
Views
1K
  • Question
How high is the hill 40m as that will add 4...
Replies
2
Views
501
B
  • Question
Could be the drainage side eg waste pipes ?
Replies
1
Views
814
M
Isolate and drain boiler. Pump up expansion...
Replies
1
Views
793
Back
Top