Replacing a TRV head | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Replacing a TRV head in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
L

LionelL

Hi all,
Hopefully someone can help me.
I need to replace a ACL Drayton Invensys RT212 radiator TRV head (the valve part is fine).
Instead of a straight swap, I'd like to take this opportunity to install a valve with a remote sensor - the current TRV is right next to a ventilation hole so doesn't work too well.
Are any of the other ACL TRV heads compatible with the valve-part of the RT212?? The TRV3 or TRV4 maybe???
Thanks for any advice
LL
 
would have thought the TR 4 remote sensor would fit
However take RT212 head down plumbers merchants and check thread the same on backing nut,you may find other makes fit also,like myson
 
Last edited by a moderator:
The RT212 and the TRV4 use exactly the same body, so all you need to get is a remote sensor. There are two types available:

ETF2: 2 metre remote setting kit Part no: 07 55 002
ETF6: 6 metre remote setting kit Part no: 07 55 006
 
Status
Not open for further replies.

Similar plumbing topics

M
Correct. It would use a standard sized nut...
Replies
3
Views
3K
  • Question
I have a 3/4" rad system i'm working on. Was...
Replies
9
Views
3K
Daley power
D
  • Question
That's good to know, thank you. Might be an...
Replies
5
Views
3K
  • Question
Just replace the whole valve. Stop being...
Replies
2
Views
2K
Evohome is not the latest technology, but it...
Replies
5
Views
2K
Back
Top