Hi Folks
Looking to change a few monobloc mixer taps in our school.
For some reason, they are connected on both hot/cold pipes to a single T piece that is fed directly by one supply, direct from a TMV.
Seeing as the water temp is already controlled I see no point in a mixer tap and would like to change them out for standard basin taps, but I'm concious the holes the monobloc taps go through are bigger.
Are you able to replace a monobloc with a standard tap, or will the larger hole mean it's not possible?
probably saving over £100 per tap if it's possible and there's a few that need doing.
Any help much appreciated.
Looking to change a few monobloc mixer taps in our school.
For some reason, they are connected on both hot/cold pipes to a single T piece that is fed directly by one supply, direct from a TMV.
Seeing as the water temp is already controlled I see no point in a mixer tap and would like to change them out for standard basin taps, but I'm concious the holes the monobloc taps go through are bigger.
Are you able to replace a monobloc with a standard tap, or will the larger hole mean it's not possible?
probably saving over £100 per tap if it's possible and there's a few that need doing.
Any help much appreciated.