Running a cold feed for sink behind the back of a freestanding oven in a domestic kitchen?

[Rob]

Is this ok, as long as run in 15mm copper, an inch away from the rear of the oven? OR are there some regs that say no? Not much choice with current layout of kitchen.

 

[Harvest Fields]

Is this ok, as long as run in 15mm copper, an inch away from the rear of the oven? OR are there some regs that say no? Not much choice with current layout of kitchen.

Is the oven built in?

 

[Rob]

Is the oven built in?

No is freestanding

 

[Harvest Fields]

Can I have a picture of the wall where it is going please?

 

[Rob]

Running horizontally in 15mm copper along this wall then freestanding oven placed against the wall. Will be about an inch gap between oven and pipe

View attachment 34205

 

[Harvest Fields]

My bad I meant of the location the cooker is going. I.e the whole wall not just the corner.

 

[ShaunCorbs]

Normally you will have a pipevoid / somewhere to run the pipes so you should be fine

 

[Harvest Fields]

Normally you will have a pipevoid / somewhere to run the pipes so you should be fine

Normally to have to avoid the hot zones. There will be a diagram with the cooker itself. Wanted a picture to also see the location of the gas pipework.

 

[Rob]

Normally to have to avoid the hot zones. There will be a diagram with the cooker itself. Wanted a picture to also see the location of the gas pipework.

is going where the black portion is on the floor. It's an electric oven with induction top. Wiring to be put in shortly.

 

[Murdoch]

Just run it close to the floor .....heat rises

 

[Ben-gee]

Go low down and why not cut a chase in the wall to get it right out of the way. I wouldn't bother plastering over it, just felt lagging and clips.