Sabre 25 he Combi fault | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Sabre 25 he Combi fault in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

ss123

Gas Engineer
Messages
46
Hi
I have been to a sabre 25he combi with no heating or ho****er today and when trying to start the fan pump starts fan comes on but the aps doesnt click so had a look inside and tried it with the case off and aps clicks and boiler ignites and stay on ,so with air supply in mind cleaned the tubes blew and poked through the venturi checked the flue (standard horizontal straight to the outside 2nd floor nothing growing around it) all look good so going to change the aps tomorrow even though it works when the case is off,i would welcome any other suggestions as this has got to be one of the tightest landlord,are these rebadged and if so who makes them.
thanks in advance.
 
Yeah very common and takes all of 10 mins to get the venturi out and cleaned and back in. Just undo the screw on either side of flue hood at the back and slide the whole lot forward with the fan on, only need it 3 inches forward to be able to get at the venturi.
 
Status
Not open for further replies.

Similar plumbing topics

Sorry, the forum rules forbid discussion of...
Replies
1
Views
3K
  • Locked
No problem when I had my First one of them I...
Replies
20
Views
491
  • Locked
Hi Everyone, Thanks for all the help, went...
Replies
22
Views
547
  • Locked
its a suprima anything is possible, just be...
Replies
2
Views
159
R
  • Locked
took the elbow off and remade joint, this was...
Replies
14
Views
296
REDSAW
R
Back
Top