salamander Mains pump? | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss salamander Mains pump? in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
S

still learning

Hi guys, I recently installed a little combi into a flat above chip shop, Mains cold is 4 bar and 12 lpm from one tap which is ok but when hot is used too well.....not good, when chippy opens the shower is unusable. My q is....as pressure isn't bad and flow is ok from one tap do you think this new salamander Mains pump will help to keep all taps usable at same time or not? Thanks for reading folks.
 
Your best bet would be to ask both Salamander and the boiler manufacturer
 
I wouldnt pump straight off the mains.....there is another thread on here somewhere I commented on and a guy from salamander replied( I think he was from salamander!) anyway he said best not to pump straight off mains....best to install a break tank and pump off that.
 
A better option might be to fit an accumulator if your pressure is good. Can uprate any pipework to the stopcock or anything?
 
Its water regs golden rule you cant pump off mains. You do have to install a break tank and pump off that.

Otherwise your trying to get more water than your neighbours
 
Have none of you ever looked at the home boost? Directly pumped, no breaktank or accumulator and WRAS approved.
 
I always thought you could pump mains up to 12 litres a minute.

I know the horse has now bolted but a good learning curve here, check your flows and pressures before going down the combi route.
 
Is it a common supply with the Chip shop?

If so may be worth looking at pipe sizes down there to see if a small upgrade will help.
 
The max it will give you is 12ltr min so as you already have that its no benefit. Accumulator as jimbob said, if you have the room and funds.
 
Salamander and Stuart Turner have both recently introduced mains direct pumps. But they are both limited to 12 litres per minute (regs) and in my opinion are not a magic cure for every job/application. small flat/single small bathroom house with combi boiler you MAY get an improvement but lets face it if the water is not there you can't have it.

For larger application you realy need the water/pressure on board not relying on the water Co. So accumulators or break tanks and pumps (room permitting has surly got th be the best way forward) but remember mains bypass on a pumped system cos pumps can and do break down.
 
Salamander and Stuart Turner have both recently introduced mains direct pumps. But they are both limited to 12 litres per minute (regs) and in my opinion are not a magic cure for every job/application. small flat/single small bathroom house with combi boiler you MAY get an improvement but lets face it if the water is not there you can't have it.

For larger application you realy need the water/pressure on board not relying on the water Co. So accumulators or break tanks and pumps (room permitting has surly got th be the best way forward) but remember mains bypass on a pumped system cos pumps can and do break down.

Thanks guys, I spoke to salamander and pump gives 12l to one outlet so ide be no better off. Thanks for you ideas but I think shop owner doesn't want to spend the money anyway. Back to gas!
 
Status
Not open for further replies.

Similar plumbing topics

A
  • Question
Stnd wrong pump for a high pressure shower...
Replies
1
Views
731
  • Question
Probably all off one main hence your problem...
Replies
3
Views
868
  • Question
hi have been a plumber for 50 years this month...
Replies
1
Views
831
  • Question
I had a chattering float valve in the loft...
Replies
2
Views
467
  • Question
Up to you, but if it’s drawing air down the...
Replies
18
Views
3K
Back
Top