- Messages
- 7
My faithful S410 F4 has all but given up the ghost and it is time to replace it. It's done well - 37 years of service, so I'm not complaining!
It features a pre-standardisation back plate, so I wanted to run a check by some kind soul before I replace it with the Drayton LP522 that's sitting on my dining table...
My CH system is gravity fed; boiler, pump, thermostat and motorised valve. All very simple.
I downloaded the 410 wiring details from Sangamo, and the details for the Drayton are 'straight out of the box':
F410 Terminal LP522 Terminal
1 3
3 L
4 N
5 N
8 4
I'm happy with most of this - the only one I'm not 100% confident about is F410 terminal 5 going to the N...
Thanks to those who took the time to read this,
Chris
It features a pre-standardisation back plate, so I wanted to run a check by some kind soul before I replace it with the Drayton LP522 that's sitting on my dining table...
My CH system is gravity fed; boiler, pump, thermostat and motorised valve. All very simple.
I downloaded the 410 wiring details from Sangamo, and the details for the Drayton are 'straight out of the box':
F410 Terminal LP522 Terminal
1 3
3 L
4 N
5 N
8 4
I'm happy with most of this - the only one I'm not 100% confident about is F410 terminal 5 going to the N...
Thanks to those who took the time to read this,
Chris