- Messages
- 17
Hi peeps. I have this boiler that went off last week, completely dead. I fault found on the control pcb and found a power Reg blown, a smoothing cap dried up and a fuse blown. Replaced all three and now the boiler fires up, gives hot water for exactly 32 seconds then shuts down with red light flashing but no error code. You can reset it and fire it up again but same thing happens. I then bought a refurbed control pcb but that didn't cure it. The fan is spinning but other that that I don't know what to go for next. Strange that it should have a pcb fault and then this secondary fault. Any advice appreciated.
Thanks, Dave
Thanks, Dave