Scalding Water From Immersion | Bathroom Advice | Plumbers Forums
Guest viewing is limited

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Scalding Water From Immersion in the Bathroom Advice area at Plumbers Forums

A

ajni

Hi,

My hot water from the immersion heater is scalding hot, the water that is heated from the oil fired boiler is fine.

The thermostat for the immersion has been replaced.

I have tried running the hot water until cold them turning the thermostat to its lowest setting and turning it up until it clicks on but the water is still scalding at a low setting.

Could a faulty element cause this ? or is there something simple I am not doing ?

We use the immersion for most hot water needs and my electric bill is a bit nuts every month. Would it pay me to have a plumber split the single channel central heating system to a two channel so I can use the oil fired boiler for hot water without heating the house.

Thanks for any advice,

Andy.
 
No way ! someone has left the stat outside its home how daft

no photos allowed from newbies from what i read cause we got hacked badly a while
a go - its a shame but it nearly brought the site down

Moderators will explain I am sure CHKing
 
If I remember rightly you're in Portadown. Go and see Joe in Bassetts on the Mahon road trading estate, or Simon in Beggs on the Armagh road.

Either of them should sort you out with a new stat.
 

Similar plumbing topics

  • Question
Except your response got me thinking. Going...
Replies
5
Views
586
https://www.tanks-direct.co.uk/files/pdf/pdf303...
Replies
8
Views
997
  • Question
Hi, I have an oil burner which is controlled...
Replies
0
Views
814
B
  • Question
Hi everyone, I have a Santon Premier Plus...
Replies
0
Views
603
Bridog
B
H
  • Question
some pics of the set up would help so we can...
Replies
1
Views
801
Back
Top