Good morning all.
Im just about to install my new shower tray (Mira Flight low) but I’ve noticed some ‘crunchiness’ at a couple of small points on the tray base. I’ve literally took the tray out of the packaging and set in position for marking out.
The soft spots are located at the opposite end to the trap, I can’t identify any cracks.
family is in need of the bathroom back and if it needs replaced, I’m not sure how I’d go to prove this wasn’t my fault and there fore have to buy a new one?
I’ve attached a couple of pics. The area highlighted is approx 2.5” long. It’s the similar on 3 of the web supports. There’s also pics of the tray edge and waste.
really appreciate the advice, thanks
Im just about to install my new shower tray (Mira Flight low) but I’ve noticed some ‘crunchiness’ at a couple of small points on the tray base. I’ve literally took the tray out of the packaging and set in position for marking out.
The soft spots are located at the opposite end to the trap, I can’t identify any cracks.
family is in need of the bathroom back and if it needs replaced, I’m not sure how I’d go to prove this wasn’t my fault and there fore have to buy a new one?
I’ve attached a couple of pics. The area highlighted is approx 2.5” long. It’s the similar on 3 of the web supports. There’s also pics of the tray edge and waste.
really appreciate the advice, thanks