Soil pipe inlet too high for toilet pan

[Mr Fixit]

I'm replacing a toilet pan & the current install has a pan connected to the soil pipe with a flexi wate, but the pan exit is almost 100% lower than the soil pipe entry. Short of setting the pan on plinth, what would be the correct install?

 

[ShaunCorbs]

lower the soil pipe

 

[Mr Fixit]

I think that's not possible. it goes into a stud wall, but without cutting the wall away I can't see where is eventually lowers.

 

[MOSSEP]

Shaun’s suggestion is the only option other than raising the pan

 

[ChippyCal]

What is your soil pipe, plastic? Attach photograph of your setup

If you use 2x offsets as above, and have the space you may get away with it.
Obviously, Rubbish doesnt go uphill, you'll get away with upto a couple mm difference
Happy flushing!

 

[Mr Fixit]

I think its a stud wall out job. Unfortunately the offset connector wont give the height shift needed.

 

[ShaunCorbs]

I think that's not possible. it goes into a stud wall, but without cutting the wall away I can't see where is eventually lowers.

only option is raise the toilet / pan

 

[Riley]

What is your soil pipe, plastic? Attach photograph of your setup

If you use 2x offsets as above, and have the space you may get away with it.
Obviously, **** doesnt go uphill, you'll get away with upto a couple mm difference
Happy flushing!

Bad idea do it properly

 

[rpm]

Bad idea do it properly

Bad idea! More like ruddy stupid idea, pipes are so far out of alignment the water level will be halfway up the pan.

 

[DGT plumbing]

Buy a different toilet with a higher outlet.

 

[rpm]

Put a macerator in.

 

[Riley]

Put a macerator in.

Your answer to everything

 

[rpm]

Your answer to everything

Now to be fair I normally put people off do I not?

 

[Mr Fixit]

Buy a different toilet with a higher outlet.

Is there a variation? Its doesn't seem to appear in the specs for the pans I've looked at.

 

[Riley]

It could be comfort height. Get the measurements and speak to a plumbers merchant

 

[Aire]

Is there a variation? Its doesn't seem to appear in the specs for the pans I've looked at.

I once had had a similar issue where the outlet was 9" high to centre (a typical toilet outlet is 7 1/2" high to centre). I was able to order a toilet to suit this waste outlet, It wasn't comfort height and it came from plumb centre, this was about 12 years ago though

 

[Mr Fixit]

That's great, thanks all. New pan then.

 

[Harvest Fields]

What is your soil pipe, plastic? Attach photograph of your setup

If you use 2x offsets as above, and have the space you may get away with it.
Obviously, **** doesnt go uphill, you'll get away with upto a couple mm difference
Happy flushing!

Really bad idea
Edit due to posting before reading full post.