Dear all, I am on the training process to be gas safe registered. There are some questions on boilers i cannot figure out. Is there anyone can help me please?
1. On this design of boiler, if the customer reported heating but no hot water would you consider a fault on one of the 2 boiler circuits(FSD circuit and main burner bircuit)?
2. During a service visit the customer says that the radiators and hot water have not been getting that hot. What would be one of your checks during the boiler service to confirm its operation and setup are not affecting this ?:
3. During a service on a room sealed boiler, the customer advises that the pilot blows out frequently and that there is often an unusual smell from the boiler. What is going to be one of your very important checks during servicing regardless of whether this was reported or not, but which relates to this ?
4. On Open Flued Boilers where the burners and air inlet are found close the the burner tray or base, what is normally found at the air inlet ?
Thanks in advance!
1. On this design of boiler, if the customer reported heating but no hot water would you consider a fault on one of the 2 boiler circuits(FSD circuit and main burner bircuit)?
2. During a service visit the customer says that the radiators and hot water have not been getting that hot. What would be one of your checks during the boiler service to confirm its operation and setup are not affecting this ?:
3. During a service on a room sealed boiler, the customer advises that the pilot blows out frequently and that there is often an unusual smell from the boiler. What is going to be one of your very important checks during servicing regardless of whether this was reported or not, but which relates to this ?
4. On Open Flued Boilers where the burners and air inlet are found close the the burner tray or base, what is normally found at the air inlet ?
Thanks in advance!