Hello everyone.
I hope that someone can provide some guidance on something I can’t figure out how it is done
Essentially my plumber has put in my thermostatic shower before the tiles have gone up
So now I need to remove the mixer and the blanking plates to tile and then to refit them afterwards
One problem
I can’t figure out how to get the things off
They just spin
I’ve tried a little elbow grease but there is no give, I don’t want to break anything
As you can see, the plumber had put in a metal sleeve, which I thought might have been stopping it - but I removed this and still the plate spins
The plate is a single piece, made by a shower company called Enki
Any thoughts on how I can get this off would be so appreciated right now, I have spent the entire afternoon on it :-/
..or should I tile around them..?
Thank you for reading
I hope that someone can provide some guidance on something I can’t figure out how it is done
Essentially my plumber has put in my thermostatic shower before the tiles have gone up
So now I need to remove the mixer and the blanking plates to tile and then to refit them afterwards
One problem
I can’t figure out how to get the things off
They just spin
I’ve tried a little elbow grease but there is no give, I don’t want to break anything
As you can see, the plumber had put in a metal sleeve, which I thought might have been stopping it - but I removed this and still the plate spins
The plate is a single piece, made by a shower company called Enki
Any thoughts on how I can get this off would be so appreciated right now, I have spent the entire afternoon on it :-/
..or should I tile around them..?
Thank you for reading