Hi,
New here. I'm a freelance Web Designer so not a Plumber so please excuse my naivety - well that's that covered, lol.
I have a couple of issues. We had a new bathroom refurbishment in 2015 but have had a few issues and the original builder just wasn't interested in assisting or advising. We had way too many blocked toilet scenarios and eventually got someone in to assist. Someone had a look and thought our pipes were collapsing so advised to get the insurance involved. Well Insurance company sent out their person who had a look with a camera, then the report came in. The Insurance said it was "bad workmanship" and something they did not cover. Apparently indoor piping used outdoors was their assessment. It looked as though a reduced had been used to connect new pan to cast iron works.
A friend got involved and sent someone to find the problem piping; as we had no real idea where the fault was located the whole floor and shower tray have been bug up. They found the piping; a white insert had been used to connect the two 4 inch pipes, effectively causing a bottle-neck and reducing aperture to 2 inches. This reducer was also embedded in a layer of concrete. In the process of digging up the floor some grit got into one of our bathroom sinks and seems to have jammed the swivel plug. It is totally jammed. I wondered whether it is possible to remove the mechanism by loosening the hex ring beneath the sink and perhaps lift out the plug? Do you get a appropriate spanner in B&Q?
New here. I'm a freelance Web Designer so not a Plumber so please excuse my naivety - well that's that covered, lol.
I have a couple of issues. We had a new bathroom refurbishment in 2015 but have had a few issues and the original builder just wasn't interested in assisting or advising. We had way too many blocked toilet scenarios and eventually got someone in to assist. Someone had a look and thought our pipes were collapsing so advised to get the insurance involved. Well Insurance company sent out their person who had a look with a camera, then the report came in. The Insurance said it was "bad workmanship" and something they did not cover. Apparently indoor piping used outdoors was their assessment. It looked as though a reduced had been used to connect new pan to cast iron works.
A friend got involved and sent someone to find the problem piping; as we had no real idea where the fault was located the whole floor and shower tray have been bug up. They found the piping; a white insert had been used to connect the two 4 inch pipes, effectively causing a bottle-neck and reducing aperture to 2 inches. This reducer was also embedded in a layer of concrete. In the process of digging up the floor some grit got into one of our bathroom sinks and seems to have jammed the swivel plug. It is totally jammed. I wondered whether it is possible to remove the mechanism by loosening the hex ring beneath the sink and perhaps lift out the plug? Do you get a appropriate spanner in B&Q?