Tado Viessmann Update - Best Result? | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Tado Viessmann Update - Best Result? in the Plumbing Jobs | The Job-board area at Plumbers Forums

Messages
35
I though I would share with you my experiences.
Vitodens 200w System boiler and Tado V3+

Boiler fitted by engineer selected from Viessmann Website (Viessman advise they have no control over fitters). Complete car crash, tried to fit two pipe system to four pipe boiler, on site six times to fit Tado and refit boiler parts:mad::mad::mad:. They will never darken my door again.

Ate humble pie and contacted my previous engineer (only went with new to get 5yr warranty).

After four hours on site and conversations with both Viessmann (good) and Tado (stunning) we got there.

My whole objective was to keep the Geofencing of the Tado, we have had it for years and love it, the boiler switches off when you leave the house.

Viessmann advised that, despite Viessmann promoting Tado there were still conflicts.

The Tado engineer was very competent and appeared to know the Viessman inside out.

So I have ended up with.

  • Vitodens 200w with Weather Compensation - THis sets boiler performance
  • Demand from Tado Thermostat (This also sets the target temperature)
  • Viessman switches off burner but keeps pump etc running when target (Tado) temp is reached
  • Geofencing from Tado :)
  • when I change my temp on my Tado, it changes automatically on the Viessmann
HOWEVER

By following the instructions from Tado the DHW part of the App has gone :(. I cannot switch the hot water on from my phone but no biggy.

So, in summary I have nearly everything I wanted. Perhaps in the future a software update will get round the DHW issue.

Good Luck
 
Glad you got it sorted , ish .
IMO all this sort of stuff just complicates a superb boiler and theres no need for it .
I will be fitting a 200 in my new gaff sometime this summer and it wont get all that lot lol .
 
Glad you got it sorted , ish .
IMO all this sort of stuff just complicates a superb boiler and theres no need for it .
I will be fitting a 200 in my new gaff sometime this summer and it wont get all that lot lol .

with you on this just use the weather comp, pointless turning it off as it does what it says keeps the house at comfort conditions. if i could fit in another 200 i would have one when we replace boiler.
 
Thermostat and extension kit. I have read about the vitodens with WC but after five years of Geofencing we are hooked on Tado.

From the top of my head. I think the hot water on wire will go in to port 3 on the thermostat.

When you paired the thermostat up (when the rings appeared you’d need to select your hot water control too)

I’m not a big fan of smart stats tbh. I don’t like people being nosey with what time I turn my heating on etc...

Although, I’ve installed loads for my customers.
 

Similar plumbing topics

Thanks for the reply whats the best suggestion...
Replies
2
Views
1K
If the op has the newer colour display model...
Replies
5
Views
4K
Do you find a solution, I have exactly the...
Replies
11
Views
2K
tinodj
T
  • Locked
Did but I had the wrong Tado, upgraded to the...
Replies
3
Views
2K
    • Like
Great summary and well done for getting it...
Replies
1
Views
2K
Back
Top